Crown Molding Details

If you’ve never mounted crown mould before, you might think it’s not as difficult as it appears. It isn’t rocket science, but it is perplexing. Let’s take a look at a typical crowning work. Though I won’t be able to cover every scenario, I hope that this article will provide you with enough details to complete the job competently. Just try to take it slowly and one step at a time.check out more

Let’s figure out the scale of the moulding, the finish, how many feet you’ll need, and which tools you’ll need to finish the job. When it comes to moulding width, I’ve found that 1/2 inch is a reasonable rule of thumb “I would suggest a 4 inch wide moulding for every foot of ceiling height, so for an 8 foot ceiling height, I would recommend a 4 inch wide moulding. There is no right or wrong response here, but if you choose a moulding that is too narrow, it will appear skinny and out of scale with the rest of the room.

Are you going to paint or stain the moulding? Apply two coats of paint to the moulding before installing it in either case, with the final coat added afterward.

Add ten percent to the linear footage of the room where crown will be mounted for waste and practise.

A mitre saw with a fine tooth saw blade, safety glasses, coping saw, work bench, wood file, wood glue, compressor with a finish nail gun and brad gun, 2 1/2″ nails and some 1″ brad nails, nail kit, and caulking gun are all tools you’ll need. NOTE: You can push 8 penny and 4 penny nails in and then set them with a nail punch, but it’s difficult to keep the piece of moulding still when banging a nail in.

Let’s start with the most important aspect of making tight joints: the pitch of the moulding as it’s cut and assembled. When cutting and installing, keep the same pitch. So, how is the pitch chosen? The degree of the bevel on the bottom, back side of the moulding will help you determine this. The bottom bevel is usually 52 degrees, but this varies depending on the manufacturer. Cut a 14-inch piece of wood to assess the saw’s pitch “remove a piece of the crown’s end Take the piece and put it on the mitre saw backwards. Change the crown on the saw’s pitch so that the back side of the molding’s bevel suits well against the saw fence. Make a pencil mark across the top of the crown on the fence when keeping it in place.